BAUBLIES AG - Glattwalzen, Festwalzen, Rollieren, Rollierwerkzeuge, Rollierwerkzeug, Festwalzwerkzeuge, Einwalzen

Start page | Contact | Site map | Imprint

Diamond finishing tool for external machining

Technical Data

Diamond finishing tool for external machining

Machining	External machining of shafts and contours
Standard mount	Square shaft 16, 20, 25 mm

Optional tool equipment

- VDI, HSK etc. mounts

- Diamond with special geometry

Use parameters to be used

Please note that this information represents guide values which must be adapted to the individual cases.
Workpiece oversize	up to 0.01 mm
Tool preclamping	up to 2 mm
Lubrication	emulsion or oil; filtration of the lubricant (<40µm) can improve the surface quality and the tool life
Pre-machining of workpiece	Surface roughness up to 15 µm
Maximum hardness of workpiece	65HRC
Speed	up to 100 rpm
Feed rate	0.05 - 0.2 mm/rev

Tip

When setting up and trying out a tool, the speed can be considerably reduced, however the feed rate per rotation is not to be decreased. Even when conducting roller burnishing under unfavorable conditions, e.g. when using high-strength materials, with insufficient lubrication, it is advisable to reduce the speed.